I have a source scope sync filter set:
(memberof=<GROUP DN>)
When I run a Start and Re-Sync all is okay.
But if I add members after the re-sync they do not get synced!
I do not see any errors in the DSA log either!
Any ideas?
I have a source scope sync filter set:
(memberof=<GROUP DN>)
When I run a Start and Re-Sync all is okay.
But if I add members after the re-sync they do not get synced!
I do not see any errors in the DSA log either!
Any ideas?
Yes, unfortunately, this can occur, where the DSA agent doesn't always see the addition without either adding some attribute/modifying some attribute or performing a full resynchronization to get it to recognize the change.
Luke
Yes, unfortunately, this can occur, where the DSA agent doesn't always see the addition without either adding some attribute/modifying some attribute or performing a full resynchronization to get it to recognize the change.
Luke