I have a source scope sync filter set:
(memberof=<GROUP DN>)
When I run a Start and Re-Sync all is okay.
But if I add members after the re-sync they do not get synced!
I do not see any errors in the DSA log either!
Any ideas?
I have a source scope sync filter set:
(memberof=<GROUP DN>)
When I run a Start and Re-Sync all is okay.
But if I add members after the re-sync they do not get synced!
I do not see any errors in the DSA log either!
Any ideas?
Yes, unfortunately, this can occur, where the DSA agent doesn't always see the addition without either adding some attribute/modifying some attribute or performing a full resynchronization to get it to recognize the change.
Luke
Depending on what DC you make the change on, in reference where your DSA is using. Also what I do, I force a delta sync Multiple times (back to back) this helps.
MemberOf is not a valid attribute to use for filtering. Use an unused attribute and set it to a known value. I.E. (ExtensionAttribute13=SyncMe)
a quest consultant suggested MemberOf !
trying (msExchExtensionAttribute45=syncme)