This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Changing the Blocking minimum duration if SQL PI is enabled.

I'm a bit confused with how much time must pass with a blocked SPID before Foglight grabs it?

I'll see something in SQL Server' activity monitor show blocking but on a lot of occasions Foglight' SQL PI won't pick it up.  

I did some digging and found a setting in "Administration -> Locks -> Blocking History" to change the "Minimal Duration (seconds)" from 90 to whatever.  We have some servers that the end users want to know of any blocking for 15 seconds or longer.  I will tweak this of course but wanted to test it.

I changed it to 15 seconds, saved it then something told me to hover over the "i" icon next to "Locks" to see what that says.  Below is what the icon says:

I have SQL PI enabled & I really need the blocking to be set to LESS THAN 90 seconds.  How do I do that??

 

Parents
  • I'm finding this not to be true. I will observe blocking going on within SQL Server' activity monitor but the same blocking will not show up in Foglight. I figured it was because the blocking I noticed in the activity monitor was usually 15 seconds or less. Hence why it wasn't showing up in Foglight. I figured it was a setting somewhere that needed adjusted. Still at a loss.
Reply
  • I'm finding this not to be true. I will observe blocking going on within SQL Server' activity monitor but the same blocking will not show up in Foglight. I figured it was because the blocking I noticed in the activity monitor was usually 15 seconds or less. Hence why it wasn't showing up in Foglight. I figured it was a setting somewhere that needed adjusted. Still at a loss.
Children
No Data